This is a template for designing your own temples for the Dilem interchangeable eyewear. This is for experimentation only and not intended for creation of mass quantities.
This was my first original design, so I’m sure it could use some updating. I used a caliper and several iterations of prototypes (didn’t have any specs).
Here’s the original design:
Right Temple
https://tinkercad.com/things/fITDfeRF8ey
Left Temple
https://tinkercad.com/things/2J39JyeWbOd
Regards,
Craig
Scaled to 100% using PLA. You may experience shrinkage with ABS, but I have not verified.
The temples work “as is” straight off the build plate, but if you’d like a bit more form-fit, set your build plate temp at ~70-80 deg C, pull the temple off the bed and quickly form the temples in any shape you like. The shape retention of PLA is impressive.
No Comments